Optimization of waste quail eggshells as biocomposites for polyaniline in ammonia gas detection

A simple, cost-effective, and novel chemical sensor for ammonia (NH₃) gas detection was developed from polyaniline (PANI)/quail eggshell (QES) composites. QES is a natural waste enriched in calcium carbonate. In this work, pure PANI was synthesized from chemical oxidation method and PANI/QES composites were prepared from physical mixing of QES with the synthesized PANI at different mass ratio. A series of complementary techniques including Fourier transform infrared and ultraviolet-visible spectrometers, scanning electron microscope with energy dispersive detection coupled with mapping, thermogravimetric analysis, and X-ray diffractometer were used to characterize the physicochemical and textural properties of the biocomposites. From the results, PANI/QES composite with a mass ratio of 1 exhibited the lowest NH₃ detection limit of 5.24 ppm with a linear correlation coefficient (R²) of close to unity (0.9932) between the signal and NH₃ gas concentration. As a whole, the PANI/QES biocomposites synthesized from this work exhibited excellent selectivity toward NH₃ gas even in the presence of other gas impurities, such as acetone, ethanol, and hexane. For the sensor reusability, the PANI/QES biocomposites can be reused in the application of NH₃ gas detection for at least 4 cycles.     

Dual application of Ti-catalyzed Li-RHC composite for H2 purification and CO methanation

2LiH + MgB₂ composite doped with TiO₂ (Li-RHC-Ti) is employed with a two-fold purpose: hydrogen purification under a H₂–CO (0.1 mol%) mixture and CO methanation. Upon dynamic cycling under CO–H₂ mixture, hydrogen release curves display a quite stable amount of pure hydrogen of about 10 wt%, short release times of around 60 min, and minor degradation. Gas analysis by Fourier transform infrared spectroscopy (FTIR) after a thermal dehydrogenation process of MgH₂ and LiBH₄ under CO evidence the conversion of CO to CH₄. Li-RHC-Ti dehydrogenated under CO shows the simultaneous formation of CH₄, CH₃OH, and B(CH₃)₃ in the gas phase. X-ray powder diffraction (XRPD) and FTIR characterizations of the solid phases of Li-RHC-Ti after both H₂–CO mixture and CO interactions demonstrate the formation of MgO, LiBO_2, and HCOO⁻ species. Li-RHC-Ti acts as a hydrogen source and promoter for the CO conversion. Reaction pathways are proposed based on experimental results and equilibrium composition calculations.     

Tailoring electromagnetic absorption performances of TiO2/Co/carbon nanofibers through tuning graphitization degrees

Low density, high stability and strong dielectric loss capacity endow carbon-based nanocomposites with superb microwave dissipation performances. Different from grapheme or carbon nanotubes, the graphitization degrees of carbon-based composites derived from the organic precursor pyrolysis can be accurately regulated by controlling the carbonization temperature. As such, their electromagnetic properties can be easily tuned. In this work, we report the preparation of TiO₂/Co/Carbon nanofibers (CNFs) through a combined approach of electrospun and carbonization at different temperatures. The nanofibers with an average diameter of 300 nm were coated by a dense layer of TiO₂ and embedded by Co/CoO nanoparticles. The performance evaluation indicated the composite obtained at 700 °C exhibits remarkably strong absorption of −63.2 dB at 9.8 GHz and wide effective absorption bandwidth of 6.4 GHz with a pretty low filling rate of 15 wt%. Further analysis on the electromagnetic behaviors shows that the composite possesses regulable impedance matching characteristic and absorption performances, implying the huge application potential under various demand conditions.     

Size controlled synthesis of well-distributed nano-silver on hydroxyapatite using alkanolamine compounds

A well-distributed nano-silver hydroxyapatite composite has been successfully prepared by a one-pot synthesis method. Hydroxyapatite was separately synthesized by a sol-gel method, then impregnated with silver nanoparticles with the mediation of Uncaria gambir Roxb. leaf extract in the presence of three kinds of alkanolamine compound; monoethanolamine (MEA), diethanolamine (DEA), and triethanolamine (TEA) as capping agents. The effect of different capping agents on the properties of the silver nanoparticles and the nano-silver hydroxyapatite composite were studied. UV–visible spectrophotometer analysis exhibited absorbance peaks at 402–439 nm which specifically corresponds to spherical silver nanoparticles. Higher optical absorbance was observed in TEA-capped silver nanoparticles, than in DEA and MEA-capped ones. X-ray diffraction (XRD) analysis showed a highly crystalline hexagonal structure for hydroxyapatite and no detected metallic silver. However, the presence of 1.65% silver was confirmed by energy dispersive x-ray (EDX) spectroscopy analysis. Transmission electron microscopy (TEM) analysis revealed spherical silver nanoparticles with a size range of 2–62 nm (smallest mean diameter of 2 nm) adhered to the hydroxyapatite surface. The TEA capped impregnated silver nanoparticles were the smallest, corresponding to the best capping performance, followed by those capped by DEA and MEA. Small-sized nanoparticles on hydroxyapatite are beneficial for highly antibacterial bone implants.     

改性碱式氯化镁晶须/丁苯橡胶复合材料制备与性能研究

以工业活性轻烧氧化镁粉和盐酸为原料,采用水溶液法制备了碱式氯化镁晶须,继而采用硅烷偶联剂对碱式氯化镁晶须进行改性,然后将其与丁苯橡胶混炼得到改性碱式氯化镁晶须/丁苯橡胶复合材料,研究了改性碱式氯化镁晶须对丁苯橡胶力学性能及热学性能的影响。结果表明：采用水溶液法制备得到的碱式氯化镁晶须结构为Mg₂（OH）₃Cl·4H₂O,呈微细纤维状,分布较均匀,长径比大于20;改性碱式氯化镁晶须的加入,可以改善丁苯橡胶的机械强度和阻燃性能。     

锂电池回收再生石墨增强水泥性能研究

废弃锂离子电池的负极活性材料主要为石墨,现阶段对于废弃锂离子电池中的石墨主要采用填埋等方法进行处理,造成了资源的浪费和环境的污染。现有的研究表明,废弃锂离子电池中的石墨经高温热解及酸浸处理后可以得到纯净的再生石墨,采用再生石墨增强水泥基复合材料的力学性能和电学性能。结果表明：再生石墨的引入可以增强材料的抗压性能和抗折性能,最大增幅分别达到了57.3%和84.4%。此外,再生石墨的加入有效降低了材料的电阻率,减少了极化时间,当再生石墨的掺加量为3%时,养护28 d后材料的电阻率仅为249 Ω·cm。该复合材料还具有典型的压敏特性。所制备的复合材料有望用于混凝土材料结构的实时动态监测。此外,对于废弃锂离子电池的全组分回收利用及功能水泥材料的研发具有重要意义。     

A next-generation wide color gamut WLED with improved spectral performance in phosphor composite functional solid

As is well known, a way to obtain a high color resolution and saturation of a liquid crystal display and thereby obtain a higher visual accuracy and comfort in the coming 5G era remains an urgent challenge. In the present study, a new type of phosphor composite material doped with Ln³⁺ ions provides a promising alternative to the color filters used in White light-emitting diodes (WLEDs), achieving a better performance regarding the realization of a wider color gamut. The advantages of this composite material are illustrated through an abundant phase and morphology analysis along with a discussion regarding the X-ray photoelectron spectroscopy of the valence bond of Ce ions, which maintain the luminescence properties of the phosphor while providing a stable and solid amorphous environment. An improved spectral performance was obtained through color filtering at 580 nm along with the regulating effects of red, green, and blue emissions according to the doped Ln³⁺ ions. Notably, we fabricated a high-performance WLED based on a Ln³⁺-doped PiG with a correlated color temperature of 5037 K, color rendering index of 72.8, and high color gamut of 91.97%, providing a new choice for the development of luminescence materials with a high color resolution and saturation.     

蚌埠市淮河南岸某高层建筑CFG桩复合地基应用探讨

以淮河南岸一级阶地某高层建筑采用CFG桩复合地基工程实例,通过利用工程地质参数复核计算、静载荷试验、沉降观测等验证资料,来探讨说明CFG桩复合地基在该区高层建筑使用的安全适用性。